LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Manual Transmission - Mu3) >> Diagnostic Information and Procedures >> DTC P0501 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the drive wheels.
  2. Start and idle the engine.
  3. Place the transmission in second gear and release the clutch pedal.
  4. Monitor VSS parameter on the scan tool. The VSS parameter should increase as the drive wheel speed increases.
  5. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records List.
scientia non olet · About LEMON Manuals