LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Sunroof System) >> Repair Instructions >> Sunroof Opening Trim Finish Lace Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Finishing Lace
    GM1564257Courtesy of GENERAL MOTORS CORP.
  1. Position the end of the sunroof finishing lace at the center of the rear center of the sunroof opening.
    2. Fig 2: Finishing Lace & Track Assembly Flange
    GM1222470Courtesy of GENERAL MOTORS CORP.
  2. Push the finishing lace (2) onto the track assembly flange (1) until fully seated around the sunroof opening.
  3. Pull the finishing lace draw cord toward the sunroof opening. Remove the cord from the periphery of the opening.
  4. Ensure that the finishing lace (2) is properly seated over the outer surface of the headliner (3).
scientia non olet · About LEMON Manuals