LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Sunroof System) >> Repair Instructions >> Sunroof Motor/Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Motor/Actuator Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  1. It is only necessary to lower the headliner. Only do those steps in the headliner replacement procedure that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement .
    2. NOTE: If the sunroof window is partially closed, remove the actuator first before moving the sunroof window forward.
  2. Disconnect the motor/actuator harness from the sunroof module.
  3. Disconnect the electrical connector from the sunroof motor/actuator.
    4. Fig 2: Identifying Sunroof Motor/Actuator
    GM1547332Courtesy of GENERAL MOTORS CORP.
  4. Remove the sunroof motor/actuator bolts (2) from the sunroof module.
  5. Remove the sunroof actuator (1) from the sunroof module.
scientia non olet · About LEMON Manuals