Secondary Air Injection Check Valve Pipe Replacement
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement |
|
| 1 | Secondary Air Injection Check Valve Bolt (Qty: 2)
CAUTION:
Refer to Fastener Caution
.
Tighten: 10 N.m(89 lb in). |
| 2 | Secondary Air Injection Check Valve Nut (Qty: 2)
CAUTION:
Refer to Fastener Caution
.
Tighten: 25 N.m(18 lb ft). |
| 3 | Secondary Air Injection Check Valve Procedure: Disconnect the electrical connector. |
| 4 | Secondary Air Injection Check Valve Gasket |