LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying MAP Sensor
    GM1581050Courtesy of GENERAL MOTORS CORP.
  1. Remove the throttle body. Refer to Throttle Body Assembly Replacement .
  2. Disconnect the engine harness electrical connector from the manifold absolute pressure (MAP) sensor.
  3. Remove the MAP sensor and seal.
scientia non olet · About LEMON Manuals