LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Fuel Pump Module Replacement (NT7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to Gasoline/Gasoline Vapors Warning .
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
    2. Fig 1: Electrical Connector And Plastic Connector
    GM2292257Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector (1) and the plastic connector (2). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Using the CH-48482:  wrench, remove the cam lock ring (1) by turning counterclockwise.
    4. Fig 2: Remove/Install Fuel Pump And O-Ring
    GM2292262Courtesy of GENERAL MOTORS CORP.
  4. Remove the fuel pump (1) and the O-ring (2).
scientia non olet · About LEMON Manuals