LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Fuel Level Sensor Replacement (NT7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Electrical Terminals
    GM2029362Courtesy of GENERAL MOTORS CORP.
  1. Push in the electrical terminals (1) and ensure the terminals are secure.
    2. Fig 2: Identifying Locking Tabs
    GM2029355Courtesy of GENERAL MOTORS CORP.
  2. Carefully insert the level sensor until the locking tabs (1) snap into the locking position.
  3. Install the fuel pump module. Refer to Fuel Pump Module Replacement (NU6)  or Fuel Pump Module Replacement (NT7) .
scientia non olet · About LEMON Manuals