LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Engine >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement 
  3. Disconnect the evaporative emission (EVAP) canister purge tube from the purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Disconnect the EVAP purge tube from the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Remove the EVAP canister valve purge tube.
scientia non olet · About LEMON Manuals