LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  1. Remove the EVAP canister valve purge tube.
  2. Connect the EVAP purge tube to the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Connect the EVAP canister purge tube to the purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement 
  5. Install the intake manifold. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals