Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying EVAP Canister

Courtesy of GENERAL MOTORS CORP.

Install the EVAP canister vent solenoid valve into the EVAP canister, with the valve aligned to the released position.

Fig 2: Identifying EVAP Canister Vent Valve

Courtesy of GENERAL MOTORS CORP.

Rotate EVAP canister vent solenoid valve clockwise in order to secure it into the locked position.

Fig 3: View Of EVAP Canister Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the EVAP canister and bolt and tighten the bolt to 10 N.m (89 lb in).

Fig 4: View Of EVAP Canister Harness & Fuel Tank Harness Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP canister harness electrical connector (2) to the vent solenoid valve.
Lower the vehicle.