LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating EVAP Purge Solenoid Electrical Connector
    GM1647981Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the engine harness electrical connector (2) from the evaporative emission (EVAP) canister purge valve.
  3. Remove the engine harness retainer (1) from the EVAP canister purge valve bracket.
    4. Fig 2: EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP canister purge valve tube from the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: Identifying EVAP Vapor Line
    GM1652164Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the chassis EVAP vapor line from the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 4: EVAP Canister Purge Valve
    GM1578478Courtesy of GENERAL MOTORS CORP.
  6. Remove the EVAP canister purge valve bracket bolt.
  7. Remove the EVAP canister purge valve with bracket.
  8. Remove the EVAP canister purge valve from the bracket.
  9. Inspect for carbon release in the EVAP canister purge valve ports. If there is any loose carbon, replace the EVAP canister and any components necessary to remove the carbon particles.
scientia non olet · About LEMON Manuals