LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Sensor Electrical Connector
    GM1647999Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the exhaust camshaft position (CMP) sensor electrical connector (1).
    3. Fig 2: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt. Intake CMP shown, exhaust CMP similar.
  4. Remove the CMP sensor.
scientia non olet · About LEMON Manuals