Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying CMP Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Inspect the CMP sensor for damage, replace as necessary.

Lubricate the CMP sensor O-ring seal with clean engine oil.
Install the CMP sensor. Intake CMP shown, exhaust CMP similar.

CAUTION: Refer to Fastener Caution .

Install the CMP sensor bolt and tighten to 10 N.m (89 lb in).

Fig 2: Identifying CMP Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the exhaust CMP sensor electrical connector (1).
Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .