LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Position Actuator Solenoid Valve Electrical Connectors
    GM1647538Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the intake (3) or exhaust (2) camshaft position actuator solenoid valve electrical connector, as required.
    3. Fig 2: CMP Actuator Solenoid Valve
    GM1578482Courtesy of GENERAL MOTORS CORP.
  3. Remove the exhaust (1) camshaft position (CMP) actuator solenoid valve bolt and valve, as required.
  4. Remove the intake (2) CMP actuator solenoid valve bolt and valve, as required.
  5. Inspect the solenoid valve O-ring seals from damage, replace as necessary.
scientia non olet · About LEMON Manuals