LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: CMP Actuator Solenoid Valve
    GM1578482Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the solenoid valve O-ring seals with clean engine oil.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the intake (2) CMP actuator solenoid valve and bolt, as required and tighten the bolt to 10 N.m (89 lb in).
  3. Install the exhaust (1) CMP actuator solenoid valve and bolt, as required and tighten the bolt to 10 N.m (89 lb in).
    4. Fig 2: Camshaft Position Actuator Solenoid Valve Electrical Connectors
    GM1647538Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake (3) or exhaust (2) camshaft position actuator solenoid valve electrical connector, as required.
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals