Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Body & Bolts

Courtesy of GENERAL MOTORS CORP.

Inspect the throttle body seal, and replace if necessary.
Position the throttle body to the intake manifold.
CAUTION: Refer to Fastener Caution .
Install the throttle body bolts and tighten to 10 N.m (89 lb in).

Fig 2: ETC Connector

Courtesy of GENERAL MOTORS CORP.

Connect the engine wiring harness electrical connector (1) to the ETC.
Install the charge air cooler outlet pipe. Refer to Charge Air Cooler Outlet Pipe Replacement .