Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of EVAP Canister Vent Solenoid Valve Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
Disconnect the evaporative emission (EVAP) canister harness electrical connector (1) from the fuel tank pressure sensor.

Fig 2: Identifying Fuel Tank Pressure Sensor

Courtesy of GENERAL MOTORS CORP.

Using a small flat-bladed screwdriver, carefully lift and release the fuel tank pressure sensor from the EVAP canister.