LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Fuel Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Wiring Harness & High Pressure Fuel Pump
    GM2035275Courtesy of GENERAL MOTORS CORP.
  1. Relieve the low and high side fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027)  or Fuel Pressure Relief (Without CH 48027)  or Fuel Pressure Relief (High Pressure Side) .
  2. Disconnect the engine wiring harness electrical connector (1) from the high pressure fuel pump.
  3. Remove the engine wiring harness clip (3) from the high pressure fuel pump cover.
  4. Remove the fuel feed intermediate pipe. Refer to Fuel Feed Intermediate Pipe Replacement .
  5. Remove the fuel feed pipe. Refer to Fuel Feed Pipe Replacement .
    6. Fig 2: High Pressure Fuel Pump & Bolts
    GM1769960Courtesy of GENERAL MOTORS CORP.
  6. Remove and discard the high pressure fuel pump bolts.
  7. Remove the high pressure fuel pump.
  8. Remove and discard the high pressure fuel pump gasket.
  9. Remove and discard the high pressure fuel pump O-ring.
    10. Fig 3: Fuel Pump Roller Lifter
    GM1769961Courtesy of GENERAL MOTORS CORP.
  10. Remove the high pressure fuel pump roller lifter, if necessary.
scientia non olet · About LEMON Manuals