LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Fuel Feed Intermediate Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying High Pressure Fuel Pump Electrical Harness & Connector
    GM2033586Courtesy of GENERAL MOTORS CORP.
  1. Relieve the high side fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027)  or Fuel Pressure Relief (Without CH 48027)  or Fuel Pressure Relief (High Pressure Side) .
  2. Remove the charged air cooler inlet pipe. Refer to Charge Air Cooler Inlet Pipe Replacement .
  3. Remove and reposition the evaporative emission retaining clip (1) from the high pressure fuel pump cover.
  4. Disconnect the high pressure fuel pump electrical connector (2).
  5. Remove the engine wiring harness clip (3) from the high pressure fuel pump cover and reposition the engine wire harness out of the way.
    6. Fig 2: View Of High Pressure Fuel Pump Cover & Bolts
    GM2033594Courtesy of GENERAL MOTORS CORP.
  6. Remove the high pressure fuel pump cover bolts (1) and cover (2).
    7. Fig 3: View Of High Pressure Fuel Pump Insulator
    GM2033606Courtesy of GENERAL MOTORS CORP.
  7. Remove the high pressure fuel pump insulator (1).
    8. Fig 4: View Of Fuel Feed Intermediate Pipe Fittings
    GM2033614Courtesy of GENERAL MOTORS CORP.
  8. Loosen the fuel feed intermediate pipe fittings at the fuel pump (1) and the fuel rail (2).
  9. Remove and discard the fuel feed intermediate pipe.
scientia non olet · About LEMON Manuals