LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Vent Solenoid Valve Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the evaporative emission (EVAP) canister harness electrical connector (1) from the fuel tank pressure sensor.
  3. Disconnect the EVAP canister harness electrical connector (2) from the EVAP canister vent solenoid valve.
    4. Fig 2: View Of Fuel Tank EVAP Line Quick Connect Fittings
    GM1651435Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fuel fill vent pipe quick connect fitting (2) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Disconnect the fuel tank EVAP line quick connect fittings (1, 3) from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: View Of EVAP Canister Bolt
    GM1652165Courtesy of GENERAL MOTORS CORP.
  6. Remove the EVAP canister bolt.
  7. Slide the EVAP canister assembly toward the driver side of the vehicle in order to remove.
    8. CAUTION: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.
  8. If reusing the EVAP canister, inspect the canister for loose carbon particles.
scientia non olet · About LEMON Manuals