LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake & Exhaust Camshaft Position Actuator Solenoid Valve
    GM2034040Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector from either the intake (2) or exhaust (1) camshaft position actuator solenoid valve, as required.
    2. Fig 2: View Of Intake & Exhaust Camshaft Position Actuators
    GM2034041Courtesy of GENERAL MOTORS CORP.
  2. Remove the exhaust (1) camshaft position actuator solenoid valve bolt and valve, as required.
  3. Remove the intake (2) camshaft position (CMP) actuator solenoid valve bolt and valve, as required.
  4. Inspect the solenoid valve O-ring seals from damage, replace as necessary.
scientia non olet · About LEMON Manuals