Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Line To Clutch Master Cylinder

Courtesy of GENERAL MOTORS CORP.

NOTE: Ensure that the clutch line locks securely in place.

Connect the clutch line (2) to the clutch master cylinder and the transaxle.
Connect the clutch hose (1) to the clutch actuator cylinder and the brake master cylinder reservoir.
Remove the shop towel and discard in a suitable container.
Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
Fill the brake/clutch reservoir with DOT 3 hydraulic fluid to the proper fluid level.
Bleed the clutch hydraulic system. Refer to Hydraulic Clutch System Bleeding .