Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Clutch Pedal Assembly

Courtesy of GENERAL MOTORS CORP.

Install the clutch pedal assembly (1).

CAUTION: Refer to Fastener Caution .

Install the clutch pedal bracket to front of dash nuts (2) and tighten to 10 N.m (89 lb in).
Move the steering column to the original position and install the mounting bolts. Refer to Steering Column Replacement .

Fig 2: View Of Clutch Master Cylinder Pushrod & Retainer

Courtesy of GENERAL MOTORS CORP.

Install the clutch master cylinder pushrod to the clutch pedal, ensure that the pushrod retainer is fully seated to the pedal.

Fig 3: Identifying Clutch Pedal Pivot Nut

Courtesy of GENERAL MOTORS CORP.

Install the clutch pedal pivot nut (1) and tighten to 10 N.m (89 lb in).

Fig 4: Identifying Clutch Position Sensor & Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (1) to the clutch position sensor (2)

WARNING: Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged.

Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn for Getrag 5 speed transmission or Clutch Pedal Position Sensor Learn for MU3 transmission.