Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Master Cylinder

Courtesy of GENERAL MOTORS CORP.

NOTE: While installing, ensure that the clutch master cylinder pushrod is aligned with he clutch pedal.

Install the clutch master cylinder while rotating 1/4 turn counterclockwise.
Uncap the reservoir and hydraulic lines.

Fig 2: Clutch Line To Clutch Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Connect the clutch line (2) to the clutch master cylinder.
Connect the clutch hose (1) to the clutch master cylinder.
Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
Connect the clutch master cylinder pushrod to the clutch pedal.
Install the clutch pedal retainer.
Bleed the clutch hydraulic system. Refer to Hydraulic Clutch System Bleeding .