Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.

Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
Install the clutch actuator cylinder to the transmission.

Fig 1: Locating Clutch Actuator Cylinder Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the clutch actuator cylinder bolts and tighten to 10 N.m (89 lb in).

Fig 2: Locating Upper Line Release Bolt

Courtesy of GENERAL MOTORS CORP.

Install the upper line release bolt and tighten to 10 N.m (89 lb in).
Install the transmission. Refer to Transmission Replacement .

Fig 3: View Of Hydraulic Clutch Hose

Courtesy of GENERAL MOTORS CORP.

Connect the clutch actuator cylinder line.
Bleed the hydraulic system. Refer to Hydraulic Clutch System Bleeding .