LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wheel Drive Shaft Into Transaxle Through J 44394
    GM857191Courtesy of GENERAL MOTORS CORP.
  1. For the left wheel drive shaft, position the J 44394-A  in the transaxle. See Special Tools .
  2. Install the wheel drive shaft until the wheel drive shaft splines are past the axle seal.
  3. Remove the J 44394-A  from the wheel drive shaft. See Special Tools .
    4. Fig 2: Locating Wheel Drive Shaft-To-Intermediate Drive Shaft Seal
    GM1394758Courtesy of GENERAL MOTORS CORP.
    NOTE: The following service procedure is for vehicles equipped with an intermediate shaft.
  4. For the right wheel drive shaft, apply a very small amount of grease to the splines of the wheel drive shaft inner joint. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  5. Install the wheel drive shaft into the intermediate drive shaft (1).
  6. Install the wheel drive shaft until it is fully seated in the transaxle.
    7. NOTE: In the following step, DO NOT pull on the wheel drive shaft. Pull only on the tripod.
  7. With the wheel drive shaft installed, grasp the inner tripot housing and pull the tripot outward to ensure that the wheel drive shaft is properly engaged. The wheel drive shaft will remain in place if properly installed.
  8. Install the lower ball joint in the steering knuckle. Refer to Lower Control Arm Replacement .
    9. Fig 3: View Of Wheel Drive Shaft Nut
    GM2001520Courtesy of GENERAL MOTORS CORP.
  9. Hand tighten the NEW wheel drive shaft nut (2) on the wheel drive shaft (1).
    10. Fig 4: View Of Tightening Wheel Drive Shaft Nut
    GM2001522Courtesy of GENERAL MOTORS CORP.
    NOTE: Step 10 is for standard disc brakes only, proceed to step 116 if the vehicle has Brembo brakes.
  10. Insert a drift or punch (5) in the brake rotor cooling fins (4) and against the brake caliper mounting bracket (1).
    11. NOTE: DO NOT air tools to tighten the wheel drive shaft nut. Use a torque wrench only.
  11. Have an assistant apply the brakes.

    Using a torque wrench and the appropriate size socket (3), tighten the wheel drive shaft nut (2).

    12. CAUTION: Refer to Fastener Caution .
  12. Tighten the wheel drive nut (2).
    • For all except the LNF and MU3, tighten the nut to 210 N.m (155 lb ft).
    • For the LNF and MU3, tighten the nut to 215 N.m (159 lb ft).
  13. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  14. Remove the support and lower the vehicle.
  15. Inspect the fluid level of the transaxle. Refer to Transmission Fluid Level and Condition Check .
scientia non olet · About LEMON Manuals