Trim Height Measurement

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Trim height is a predetermined measurement relating to vehicle ride height. Incorrect trim heights can cause the vehicle to bottom out over bumps, damage to the suspension components and symptoms similar to wheel alignment problems. Check the trim heights when diagnosing suspension concerns and before checking the wheel alignment.

NOTE: All dimensions are measured vertical to the ground. Trim height should be within ±10 mm (±0.39 in) to be considered correct.

Perform the following before measuring the trim heights:

Set the tire pressure to the specifications shown on the certification label. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label .
Check the fuel level. Add additional weight if necessary to simulate a full tank.
Make sure the passenger and rear compartments are empty, except for the spare tire.
Make sure the vehicle is on a flat and level surface, such as an alignment rack.
Check that all the vehicle doors are securely closed.
Check that the vehicle hood and rear deck lids are securely closed.
Check for installed after market accessories or modifications that could affect trim height measurement.