LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Drum Brake System) >> Repair Instructions >> Rear Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear brake backing plate to the rear axle assembly.
  2. Install the rear wheel bearing and hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (Disc Brake) or Rear Wheel Bearing and Hub Replacement (Drum Brake) .
    3. Fig 1: View Of Rear Park Brake Cable End Fitting
    GM890720Courtesy of GENERAL MOTORS CORP.
  3. Install the rear park brake cable end fitting (1) to the drum brake backing plate.
  4. Install the wheel cylinder. Refer to Rear Brake Cylinder Replacement .
  5. Install the brake shoes. Refer to Brake Shoe Replacement .
scientia non olet · About LEMON Manuals