Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Brake Dust Warning .

Remove the brake drum. Refer to Brake Drum Replacement .

Fig 1: Brake Adjuster Actuator Lever Spring

GM2180668

Courtesy of GENERAL MOTORS CORP.

Remove the brake adjuster actuator lever spring (1).

Fig 2: Brake Adjuster Actuator Lever

GM2180674

Courtesy of GENERAL MOTORS CORP.

Remove the brake adjuster actuator lever (1).

Fig 3: Brake Shoe Hold Down Spring And Cup

GM2180676

Courtesy of GENERAL MOTORS CORP.

Remove the brake shoe hold down spring and cup (1) assemblies by compressing the spring and rotating the assembly 1/4 turn.
Remove the 2 hold down spring and cup assembly pins.

Fig 4: Brake Shoe Adjuster

GM2180677

Courtesy of GENERAL MOTORS CORP.

Spread the top of the brake shoes apart slightly and remove the brake shoe adjuster (1).

Fig 5: Upper Brake Shoe Return Spring

GM2180682

Courtesy of GENERAL MOTORS CORP.

Remove the upper brake shoe return spring (1).

Fig 6: Primary Brake Shoe

GM2180683

Courtesy of GENERAL MOTORS CORP.

Rotate the primary brake shoe (1) toward the wheel hub assembly and release the brake shoe from the lower brake shoe return spring.

Fig 7: Lower Brake Shoe Return Spring

GM2180686

Courtesy of GENERAL MOTORS CORP.

Remove the lower brake shoe return spring (1).
Inspect the drum brake hardware and replace any damaged components as necessary. Refer to Drum Brake Hardware Inspection .