Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lower Brake Shoe Return Spring

Courtesy of GENERAL MOTORS CORP.

Install the lower brake shoe return spring (1).

Fig 2: Primary Brake Shoe

Courtesy of GENERAL MOTORS CORP.

Position the primary brake shoe (1) to the drum brake backing plate and connect the brake shoe to the lower brake shoe return spring.

Fig 3: Upper Brake Shoe Return Spring

Courtesy of GENERAL MOTORS CORP.

Install the upper brake shoe return spring (1).

Fig 4: Brake Shoe Adjuster

Courtesy of GENERAL MOTORS CORP.

Spread the top of the brake shoes apart slightly and install the brake shoe adjuster (1).

Fig 5: Brake Shoe Hold Down Spring And Cup

Courtesy of GENERAL MOTORS CORP.

Install the 2 hold down spring and cup assembly pins.
Install the brake shoe hold down spring and cup (1) assemblies by compressing the spring and rotating the assembly 1/4 turn.

Fig 6: Brake Adjuster Actuator Lever

Courtesy of GENERAL MOTORS CORP.

Install the brake adjuster actuator lever (1).

Fig 7: Brake Adjuster Actuator Lever Spring

Courtesy of GENERAL MOTORS CORP.

Install the brake adjuster actuator lever spring (1).
Adjust the drum brakes. Refer to Drum Brake Adjustment .
Install the brake drum. Refer to Brake Drum Replacement .