LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Drum Brake System) >> Repair Instructions >> Drum Brake Adjusting Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a light coat of high temperature brake lubricant to the brake shoe adjuster screw threads.
  2. Assemble the brake shoe adjuster, setting the adjuster to the fully retracted position.
    3. Fig 1: Brake Shoe Adjuster
    GM2180678Courtesy of GENERAL MOTORS CORP.
  3. Spread the top of the brake shoes apart slightly and install the brake shoe adjuster (1).
    4. Fig 2: Brake Adjuster Actuator Lever
    GM2180674Courtesy of GENERAL MOTORS CORP.
  4. Install the brake adjuster actuator lever (1).
    5. Fig 3: Brake Adjuster Actuator Lever Spring
    GM2180668Courtesy of GENERAL MOTORS CORP.
  5. Install the brake adjuster actuator lever spring (1).
  6. Adjust the drum brakes. Refer to Drum Brake Adjustment .
  7. Install the brake drum. Refer to Brake Drum Replacement .
scientia non olet · About LEMON Manuals