LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Parking Brake System) >> Repair Instructions >> Parking Brake Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Warning Lamp Switch Mounting Screw & Electrical Connector
    GM891314Courtesy of GENERAL MOTORS CORP.
  1. Align the park brake warning lamp switch locating tab to the locating hole on the park brake lever assembly.
  2. Install the switch to the park brake lever.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the park brake warning lamp switch mounting screw (1).

    Tighten:  Tighten the screw to 3 N.m (27 lb in).

  4. Connect the park brake warning lamp switch electrical connector (2).
  5. Install the front floor console upper trim plate. Refer to Console Front Trim Plate Replacement .
  6. Verify correct park brake warning lamp operation.
scientia non olet · About LEMON Manuals