LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Replacement (Without RPO LNF) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Brake Caliper Guide Pin Bolts
    GM1385619Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper to the brake caliper bracket.
  2. CAUTION: Refer to Fastener Caution .
  3. Install the brake caliper guide pin bolts (1).

    Tighten:  Tighten the bolts to 34 N.m (25 lb ft).

  4. Fig 2: View Of Front Brake Hose
    GM890982Courtesy of GENERAL MOTORS CORP.
  5. Remove the caps or plugs from the brake caliper opening and the brake hose (3).
  6. NOTE: Do not reuse the copper brake hose gaskets.
  7. Install NEW copper brake hose gaskets (2) to the brake hose-to-caliper bolt (1) and to the brake hose (3).
  8. Install the brake hose and the brake hose-to-brake caliper bolt to the brake caliper.

    Tighten:  Tighten the bolt to 48 N.m (35 lb ft).

  9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Rear Brake Caliper - Cobalt SS) or Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  10. Remove the wheel nuts retaining the brake rotor to the wheel hub.
  11. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  12. Lower the vehicle.
  13. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  14. Slowly release the brake pedal.
  15. Wait 15 seconds, then gradually apply the brake pedal approximately 2/3 of its travel distance again until a firm brake pedal apply is obtained. This will properly seat the brake caliper pistons and brake pads.