LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Replacement (With RPO LNF) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Identifying Brake Hose Fitting & Gaskets
    GM1989060Courtesy of GENERAL MOTORS CORP.
  3. Remove the brake hose fitting bolt (1).
  4. Remove the brake hose fitting gaskets (2) from the brake hose (3).

    Discard the brake hose fitting gaskets.

  5. Cap the brake hose fitting to prevent brake fluid loss and contamination.
  6. Remove the front disc brake pads. Refer to Front Disc Brake Pads Replacement (With RPO LNF) .
    7. Fig 2: Removing & Installing Brake Caliper-To-Knuckle Mounting Bolts
    GM1349659Courtesy of GENERAL MOTORS CORP.
  7. Remove the brake caliper bolts (1).
  8. Remove the brake caliper from the wheel knuckle.
scientia non olet · About LEMON Manuals