Installation Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake pads (1) to the caliper.
- Install the upper caliper guide pin (2) through the caliper, inner and outer brake pads.
- Using a hammer and punch seat the upper guide pin to the outer caliper half. Ensure the caliper guide pin is seated into the outer caliper pin seat.
- Install the brake pad retainer (1) under the upper caliper pin assembly.
- Rotate brake pad retainer downward.
- Hold the brake pad retainer down and install the lower caliper guide pin (2) through the caliper, inner and outer brake pads.
- Using a hammer and punch seat the upper guide pin to the outer caliper half. Ensure the caliper guide pin is seated into the outer caliper pin seat. Ensure the brake pad retainer is centered retaining both brake pads.
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .