LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Hydraulic Brake System) >> Repair Instructions >> Rear Brake Hose Replacement (Axle to Caliper) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Brake Hose
    GM1385043Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps or plugs from the opening in the brake caliper and the brake hose.
    2. NOTE: Install NEW copper brake hose gaskets (2).
  2. Assemble the brake hose fitting bolt (1) and the copper brake hose gaskets (2) to the brake hose (3).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the brake hose assembly to the brake caliper.

    Tighten:  Tighten the bolt to 48 N.m (35 lb ft).

    4. Fig 2: View Of Brake Hose Mounting Bracket - Rear
    GM1385044Courtesy of GENERAL MOTORS CORP.
  4. Install the brake hose to the brake hose mounting bracket. Align the hose fitting with the notch in the bracket.
  5. Install the hose retaining clip (3) onto the hose fitting at the hose bracket.
  6. Using a backup wrench on the hose fitting, connect the brake pipe fitting at the rear brake hose.

    Tighten:  Tighten the fitting to 21 N.m (15 lb ft).

  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Ensure the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
  9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Rear Brake Caliper - Cobalt SS)  or Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals