Installation Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Position the hose clamp (1) to the vacuum hose and install the hose to the intake manifold vacuum port.
- Install the power brake booster vacuum sensor (1) to the power vacuum brake booster.
If necessary, a small amount of denatured alcohol can be used as an assembly aid for installing the vacuum sensor to the vacuum booster grommet. Do not use soap.
- Position the hose clamp (2) to the vacuum hose (3) and install the hose to the power brake booster vacuum sensor.
If necessary, a small amount of denatured alcohol can be used as an assembly aid for installing the vacuum hose to the vacuum sensor. Do not use soap.
- Connect the power brake booster vacuum sensor electrical connector.