LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement (With RPO LNF) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Hose, Fitting & Gaskets
    GM1989060Courtesy of GENERAL MOTORS CORP.
  1. Assemble the brake hose fitting bolt (1) with 2 new brake hose fitting gaskets (2) to the brake hose (3).
    2. CAUTION: Refer to Fastener Caution .
  2. Install the brake hose assembly to the caliper.

    Tighten:  Tighten the brake hose fitting bolt to 40 N.m (30 lb ft).

    3. Fig 2: Identifying Front Brake Hose Bracket Bolt
    GM1989059Courtesy of GENERAL MOTORS CORP.
  3. Install the front brake hose bracket bolt (1).

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    4. Fig 3: View Of Front Brake Pipe Fitting
    GM1989058Courtesy of GENERAL MOTORS CORP.
  4. Connect the front brake pipe fitting (1).

    Tighten:  Tighten the fitting to 19 N.m (14 lb ft).

  5. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Rear Brake Caliper - Cobalt SS)  or Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals