LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column opening filler. Refer to Steering Column Opening Filler Replacement .
  2. Release the electric power steering wiring harness from the brake pedal bracket.
  3. Release the accelerator pedal position sensor jumper harness from the brake pedal bracket.
    4. Fig 1: View Of APP Sensor Harness Connector
    GM927716Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the accelerator pedal position sensor.
    5. Fig 2: Locating Brake Pedal Pushrod Nut
    GM1912299Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake pedal pushrod nut (1).
    6. Fig 3: Identifying Brake Pedal Pushrod Washer
    GM1912300Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pedal pushrod washer (1).
  7. Remove the brake pedal pushrod from the brake pedal pivot pin.
    8. Fig 4: Identifying Brake Booster Nuts
    GM1912303Courtesy of GENERAL MOTORS CORP.
  8. Remove the vacuum brake booster nuts (1).
  9. Remove the brake pedal bracket-to-steering column bracket bolt.
  10. Lower the brake pedal assembly and disconnect the brake pedal position sensor electrical connector.
  11. Remove the brake pedal assembly, with the accelerator pedal position sensor from the vehicle.
    12. Fig 5: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  12. Remove the accelerator pedal position sensor mounting bolts and remove the sensor assembly.
scientia non olet · About LEMON Manuals