LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Hydraulic Brake System) >> Diagnostic Information and Procedures >> Brake Warning Indicator Malfunction >> Component Testing >> Park Brake Switch Malfunction

Park Brake Switch Malfunction

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the park brake switch.
  2. Test for infinite resistance between the signal terminal A and ground with the park brake released.
    • If less than the specified value, replace the park brake switch.
  3. Test for less than 1 ohm between the signal terminal A and ground with the park brake applied.
    • If greater than the specified range, replace the park brake switch.
scientia non olet · About LEMON Manuals