Installation Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install the NEW wheel stud into the wheel bearing hub.
- Add enough washers (1) in order to draw the stud into the hub.
- Install the wheel nut (2) with the flat side against the washers.
- Tighten the wheel nut until the head of the wheel stud is fully seated against the back of the bearing hub flange.
- Remove the wheel nut and the washers.
- Install the brake drum. Refer to Brake Drum Replacement .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.