LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing and Hub Replacement (Drum Brake) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub Assembly - Drum Brake
    GM890719Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub assembly to the brake backing plate and the rear axle assembly.
    2. Fig 2: Rear View Of Wheel Bearing/Hub Assembly
    GM890721Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the wheel bearing/hub assembly mounting nuts (3) to the axle assembly. Tighten the nuts evenly, in a cross-pattern.

    Tighten:  Tighten the nuts to 45 N.m (33 lb ft) plus 30 degrees.

  3. Connect the electrical connector (2) to the wheel speed sensor, if equipped with ABS.
  4. Remove the support (1) from the brake backing plate.
  5. Install the plug to the drum brake actuator access hole in the backing plate.
  6. Install the brake drum. Refer to Brake Drum Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals