LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing and Hub Replacement (Disc Brake) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Without disconnecting the hydraulic brake flex hose, remove and support the rear brake caliper and bracket as an assembly, and remove the rear brake rotor. Refer to Rear Brake Rotor Replacement .
  4. Disconnect the electrical connector from the wheel speed sensor.
    5. Fig 1: View Of Wheel Bearing/Hub Assembly - Disc Brake
    GM1385060Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel bearing/hub assembly mounting nuts.
    6. NOTE: If removing the rear wheel bearing/hub assembly to service other suspension components, relocate and secure the wheel bearing/hub assembly to the side.
  6. Remove the wheel bearing/hub assembly and the disc brake backing plate from the rear axle assembly.
scientia non olet · About LEMON Manuals