LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing and Hub Replacement (Disc Brake) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub Assembly - Disc Brake
    GM1385060Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub assembly and the brake backing plate to the rear axle assembly.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the wheel bearing/hub assembly mounting nuts to the axle assembly. Tighten the nuts evenly, in a cross-pattern.

    Tighten:  Tighten the nuts to 45 N.m (33 lb ft) plus 30 degrees.

  3. Connect the electrical connector to the wheel speed sensor.
  4. Install the brake rotor, and install the brake caliper and bracket as an assembly. Refer to Rear Brake Rotor Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals