LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> Heated Seat Inoperative >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, place the heated seat switch in the high heat position. The seat cushion and seat back should get warm.
    • If the heated seat is inoperative or always ON, refer to Heated Seats Malfunction below.
  2. Ignition ON, place the heated seat switch in the low heat position. The seat cushion and seat back should get warm.
    • If the heated seat is inoperative, refer to the Heated Seat Switch component test. If the switch tests normal, replace the heated seat module.
  3. Observe the heated seat switch temperature indicators while pressing the appropriate heated seat switch through the high and low heat positions. The appropriate indicators should illuminate when the switch is pressed.
    • If either indicator does not illuminate or is always ON, refer to Heated Seat Switch Indicator Malfunction below.
scientia non olet · About LEMON Manuals