LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to Battery Disconnect Warning .
  1. Disconnect the negative battery cable from the battery negative terminal.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the electrical connector at the vehicle speed sensor.
    4. Fig 1: Vehicle Speed Sensor (VSS) & Retaining Stud
    GM104524Courtesy of GENERAL MOTORS CORP.
  4. Remove the retaining stud and the sensor. Pull straight out in order to avoid damage to the case.
scientia non olet · About LEMON Manuals