LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and dry the vehicle speed sensor.
    2. Fig 1: Vehicle Speed Sensor (VSS) & Retaining Stud
    GM104524Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the vehicle speed sensor and the retaining bolt.

    Tighten:  Tighten the stud to 12 N.m (97 lb in).

  3. Install the electrical connector at the sensor.
  4. Remove the safety stands.
  5. Lower the vehicle.
  6. Connect the negative battery cable.

    Tighten:  Tighten the terminal bolt to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals