LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Front Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The transaxle bolts must be torqued in a mandatory sequence as shown.
    Fig 1: View Of Front Transaxle Mount
    GM1506918Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the front transaxle mount and transaxle bolts.

    Tighten:  Tighten the bolts to 90 N.m (66 lb ft).

    2. Fig 2: View Of Front Transaxle Mount Through Bolt
    GM1497621Courtesy of GENERAL MOTORS CORP.
  2. Hand tighten the front transaxle mount thru bolt.
    3. NOTE: The front and rear transmission mounts must be allowed to settle with the thru bolts loosened.
  3. Loosen the rear trans mount thru bolt.
  4. Tighten the transmission mount thru bolts in the following order.

    Tighten: 

    1. Tighten the rear bolt to 100 N.m (74 lb ft).
    2. Tighten the front bolt to 100 N.m (74 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals