LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Park/Neutral Position Switch Replacement >> Installation Procedure (New Switch)

Installation Procedure (New Switch)

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transaxle Range Switch And Mounting Bolts
    GM1233691Courtesy of GENERAL MOTORS CORP.
  1. Make sure the transaxle manual shaft is in the Neutral position.
  2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
  3. Tighten the transaxle range switch bolts to 20 N.m (15 lb ft).
    4. WARNING: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.
  4. Install the transaxle range switch lever and nut and tighten to 35 N.m (26 lb ft).
    5. Fig 2: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch
    GM1233683Courtesy of GENERAL MOTORS CORP.
  5. Connect the transaxle range switch electrical connector.
    6. NOTE: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.
  6. Install the shift control cable to transaxle range switch lever and verify proper operation.
scientia non olet · About LEMON Manuals