LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Automatic Transmission - 4T45-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the oil pan for dents or damage. Dry the oil pan before installation.
    2. Fig 1: Locating Oil Pan Gasket
    GM104471Courtesy of GENERAL MOTORS CORP.
  2. Install the oil pan gasket. Use a new gasket if the sealing ribs are damaged.
    3. Fig 2: View of Oil Pan
    GM104468Courtesy of GENERAL MOTORS CORP.
  3. Install the oil pan. Replace the bottom pan if damaged.
    4. Fig 3: Identifying Oil Pan Bolts
    GM104466Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Install the oil pan attaching bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Lower the vehicle.
  6. Check the pan for leaks. Refill the transmission to the proper level. Refer to Fluid Capacity Specifications .
  7. Recheck the fluid level. Refer to Transmission Fluid Level and Condition Check .
  8. Inspect the oil pan gasket for leaks.
scientia non olet · About LEMON Manuals